1. There are few pores inside the casting, and the rigidity of the product after heat treatment can be greatly improved, even exceeding that of die-casting products. 2. The product has low density. Relying on liquid self-gravity molding, the density of low-pressure casting machine products is lower than that of die casting, and its strength is also slightly lower, but its elongation is higher. 3. ...
In addition to the common characteristics with other plating types, the chromium plating process also has the following special points: (1) The dispersion ability of the plating solution is poor. To obtain a uniform coating, special fixtures (including pictographic anodes) must be designed according to the geometry of the parts. ); (2) The current efficiency is low (generally 13~16%), a large amou...
Machining centers are unable to process small molds with small tools, and the cost is high. The advantage of the engraving machine is engraving, but if the hardness of the processed material is relatively high, it will be unable to do its job. The emergence of engraving and milling machines can be said to be the shortcomings of both. The machining center can realize the centralized processin...
The reason why the slitting machine's winding always goes off track: 1. Problem of equipment deviation 2. Air leakage occurs in parts of the reel 3. Is the pressure at both ends of the reel consistent? What cannot be ignored during production is to pay attention to changes in product tension, etc. Slitting machine is a mechanical equipment that cuts wide-width paper, mica tape or film into multipl...
New Blog
Copyright © 2024 D&S Automatic Co.,Ltd.. All Rights Reserved.
IPv6 network supported